Silicon Image 3124, 3132 and 3531 SATA controllers, including OEM rebadges from Adaptec.
PIO, MWDMA, UDMA
When marvell 88SM4140 PMP is attached, NCQ is disabled for devices behind it
If a card using this driver does not seem to present individual drives to the system's BIOS for bootup purposes, re-flashing the card to the "base" (non-"raid") bios may resolve the issue. Despite documentation that says to choose "JBOD" in the raid firmware for this purpose, that option does not seem to exist in recent revisions. Card firmware is available from Silicon Image
Spurious interrupts are expected on SiI3124 suffering from IRQ loss erratum on PCI-X
DMA Context Switch corruption erratum will occur on any error condition while in PMP mode if 3 or more devices have active commands
msi - Enables PCI MSI instead of legacy PCI interrupts.
WARNING:This will be available only on chipsets whose MSI implementation is not broken.
Hardware flashing hints
NOTICE: NB: flashing a rom image is an advanced procedure. Instructions below describe add on card flashing procedure.
PCI-X (64 bit PCI) cards such as SYBA 40009 may need to be placed temporarily in a 5V PCI (32 bit) slot in order to flash successfully, as some flash memory requires 5V to program.
After flashing, during POST, the "base"/"non-raid" card may not display any information on screen, or may very briefly display information about connected drives. This does not seem to affect operation.
Commonly available environments that may work to perform the firmware change: Knoppix live disks can boot freedos, which can then run the Silicon Image flash utility. Flashrom, a utility from the coreboot project may be used to flash the rom if freedos is not available. Live disks including flashrom likely include Knoppix and Partition Magic.